Q&A Community

277B Blade Will Not Tilt

Actual Question

Top Replies

Needs to be 12 volts. Check fuses, then follow worktool harness back to rear of machine and unplug connector in engine compartment. Think it is pin 3 (906 blue). If has voltage there, wire broken in harness.

More Replies

knogen said: Needs to be 12 volts. Check fuses, then follow worktool harness back to rear of machine and unplug connector in engine compartment. Think it is pin 3 (906 blue). If has voltage there, wire broken in harness. Thank you, knogen. Knowing it should be 12v, I checked the fuse and found one was burned out. Changed it last night and worked like a charm. Thanks again!

You must be a registered user to add a comment. If you've already registered,
sign in. Otherwise, register and sign in.